TIS-BAT-CM is a ceiling mount ultrasonic + passive infrared motion sensor beside the light intensity meter that afford a convenience and saving energy for big area converge and it can detect the smallest move . It is recommended to install TIS-BAT-CM in big hall , offices, big living room….
The SMART-BAT is a low-voltage PIR/Ultrasonic Occupancy
sensor that works with TIS 24 DC power Supply or other
class 2 power supplies, to control lighting automatically and
saving energy. The sensor can be connected to TIS Digital
Inputs for max saving energy logic.
SENSOR INITIALIZATION
Following power-on, the SMART-BAT sensor is fully
operational after 30 sec warm-up.
SENSOR OPERATION
Multi Tech Mode:This is the default mode of operation
for the sensor. PIR technology turns lights on in this mode;
however, motion detection by either technology will keep the
lights ON. If neither technology detects motion, the lights
turn off after the delayed-OFF time.
Single tech mode: Only one technology is active in this
mode. The technology is selected by the dip switches
Motion detection by the selected technology – PIR or
ultrasonic – will turn ON the lights as well as keep them ON.
When motion is not detected, the light will turn OFF after the
delayed-OFF time.
Delayed off time: The sensor is designed to turn the
light OFF if no motion is detected after a specified time. The
length of time is called the delayed-off time and is set using
the timer knob on the sensor. The adapting patterns will
modify the delayed-OFF time to fit the parameters of each
installation based on environmental conditions and
occupancy patterns.
Walk- through Mode: The walk- through feature is useful
when a room is momentarily occupied. With this feature, the
sensor will turn the lights OFF shortly after the person
leaves the room.
The walk-through feature works as follows: When a person
enters the room, the lights will turn on. If the person leaves
the room before the default walk-through time-out of 2.5
minutes, the sensor will turn the lights OFF. If the person
stays in the room for longer than 2.5 minutes, the sensor will
proceed to the standard operation.
LED Operation: There are two LED indicators that will flash
when motion is detected. The LED flash can be disabled
using the LED disable switch setting. A Green flash indicates
motion detection by ultrasonic technology. A Red flash
indicates motion detection by infrared technology.
IR Detector: Pyroelectric RF Immunity:
Dual elements
Approvals / qualification: RF Immunity: 20 V/m 10-1000 MHz;
CCC(Pending) 20 V/m 10-1000 MHz;
Power Supply: 10 V/m 1-2 GHz
24 Vdc; 45 mA at 24 Vdc Ultrasonic Frequency:
Housing Material: 40KHz
High-impact ABS Operating Temperature
Dimensions: Range:
Ø110 x 56 mm ( Dia x D ) -10°C to +50° C
Approvals / qualification: Accessories:
CCC(Pending) Trim ring for solid ceiling;
CE (Pending) CE (Pending)